Setting new standards in applications across Australia.
Fenner are proud to release both the Apex QuarryMaster-M and Apex RockMaster belts as a part of our stock range. These belts are on the floor inventory and normally available ex-stock from your nearest branch or distributor.
With an M Grade cover compound that exceeds Australian Standards, the belts will continue to be a market-leading product that sets the benchmark for performance, quality and overall value for money.
So whether you are carrying coal, rock, iron ore or any other suitable product, this Stock belt will consistently outperform those who claim to be the “same” as the Apex belt.
Pulley Classifications
Type A – High tension, head, drive and tripper
Type B – Low tension, tail, bend and take-up
Type C – Low tension snub
Pulley diameters
Pulley diameters shown apply to belts operating at over 60% of maximum allowable working tension.
Diameters of all pulleys must be reduced by 20% where belts are operating at less than 60% of allowable working tension.
For belts at less than 30% of allowable tension, the diameters of Type A pulleys can be further reduced by 20%.
Working tensions
Working tensions assume a reasonably well maintained plant, with infrequent controlled starts and moderate impact.
For more severe service, ie: poor loading, frequent loaded or DOL starts, short time cycles then reduce the above values by 15%.
For extreme service, ie: poorly maintained plant, chemical aggression, bad loading and starting, then reduce the above values by 30%