An economical alternative to premium Apex QuarryMaster.

This tough, value-for-money-belting is an economical option over the premium Apex QuarryMaster range.

100% Australian Made and backed by the Fenner group, this Stock range offers a real cost saving without the normal high risks of a belt made in an unknown location and to an unknown specification. With this belt in a Stock range, it is readily available from your nearest branch or distributor.

Pulley Classifications

Type A – High tension, head, drive and tripper
Type B – Low tension, tail, bend and take-up
Type C – Low tension snub

Pulley diameters

Pulley diameters shown apply to belts operating at over 60% of maximum allowable working tension. Diameters of all pulleys must be reduced by 20% where belts are operating at less than 60% of allowable working tension. For belts at less than 30% of allowable tension, the diameters of Type A pulleys can be further reduced by 20%.

Working tensions

Working tensions assume a reasonably well maintained plant, with infrequent controlled starts and moderate impact. For more severe service, ie: poor loading, frequent loaded or DOL starts, short time cycles then reduce the above values by 15%. For extreme service, ie: poorly maintained plant, chemical aggression, bad loading and starting, then reduce the above values by 30%.

 

If this is what you need, contact us here.